Programmable (XSTAT)

Key features of the new XSTAT

• Intuitive interface and user-friendly menu.
• Pre-programmed for easy start-up and optimal heat control.
• 4-event clock for intelligent control and perfect comfort.
• 14 mm installation depth permits flush mounting in standard socket.
• Menu in five different languages.
• Built-in temperature limitations to protect wooden floors.
• Floor & air sensors ensure precise control of temperature.

The new XSTAT can be installed in just minutes, and provides homeowners with unsurpassed control and ease of use. The convenient mobile-phone style keypad is both simple and straightforward, so you won’t need special training. In fact, you won`t even need the instruction booklet!

THERMOSTAT FUNCTIONS:

Individual programming of events:

The factory-set periods and temperatures can be changed according to individual needs:

• 4 events at 5 days/2events day 6 & 7
• 4 events at 6 days/2 events day 7
• 4 events at 7 days

XSTAT is with built-in 4-events program for automatic comfort and setback temperature.

Comfort mode:

The temperature can be temporarily changed at the touch of a button, without changing the normal programme – a tremendous convenience on an extra chilly day.

Manual mode:

The scheduled program can be easily cancelled during holidays. The thermostat will stay at the desired temperature until the manual mode is cancelled.

And thanks to XSTAT, the thermostat calculates when the heating has to be switched on to make sure that the floor is warm at the appointed hour. It’s even possible to choose the type of heater and the floor covering to achieve better and safer comfort heating.

Adjustable offset:

With underfloor heating, floor temperature must be higher than the desired ambient room temperature. Offset is used to compensate for any difference between the thermostat and room thermometer. It is possible to adjust the offset by +/-5°C.

Child lock:

The convenient child lock prevents accidental changes to the thermostat settings. The display will be marked with a padlock symbol.

CE Marking:

The thermostat meets the requirements of the following standards:

EMC directive: EN61000-6-1:2001, EN61000-6-3:2001 Low voltage directive: EN60730-1, EN60730-2-9

Supply voltage	230V ±15%
Output relay SPST or 1A inductive load	16A, 3,600W
Built-in interrupter	2-pole, 16A
Temperature range	0 / +40 °C
Limitation of range	+5 / +55 °C
Clock function	4-events program/7 days
Ambient temperature during operation	0/+40°C
On/off differential	0.4°C
Housing	IP 20
Sensor Type	NTC, 3m
Dimensions	(H/W/D) 86 x 86 x 34 mm
Size of display	H/W) 26 x 39 mm

MOUNTING OF FLOOR SENSOR:

The floor sensor is used for temperature regulation in floor surfaces.

The floor sensor must be situated in the centre of the heating cables. The sensor wire must not cross or touch any of the heating wires.

MOUNTING OF THE THERMOSTAT:

The single gang mounting box must have a depth of no less than 25 mm

1. Use a screwdriver in both sides to open the lock. The cover must be dismounted.
2. Connect cables.
3. The thermostat is mounted in the wall socket. The cover is remounted.

Please note: As with all electrical projects which are subject to Part P Building Regulations, all elecrical work should be carried out by a certified/qualified electrician. All work must conform to BS 7671:2001 and the current IEE Wiring Regulations.

---