The Foil heater is designed to be installed under floating wood floors only. If installing a wood floor involves using a adhesive or glue a alternative system will be required. The Warmup DWS loose wire or Sticky mat system can be used for wood flooring that is to be glued. The heater should be covered […]
Can the foil heater be installed under a glued wood floor ? Read More »
The Warmup insulated underlay must be used under the foil heating system. Friction damage can occur if the foil heater is installed between two hard surfaces, installing the insulated underlay will cushion and protect heater from damage. Friction damage can occur if the heater has been installed between to hard surfaces. If using another brand
Is the insulated underlay required with the foil system? Read More »
The 4iE is compatible with Alexa so you can control your heating using voice control. To enable your 4iE to work with Alexa follow these steps: Firstly, make sure your 4iE is registered to your My Warmup account. You can do this through the MyHeating app or through the my.warmup.com web protal. Open the Alexa
Can the 4iE be used with Alexa? Read More »
Follow these steps on how to set the number of programs per day on TSTAT. You can select the number of programs to be used each day. For example, you can set it to run all 4 programs or only 2 (1st and 4th) or none (0) • To change the amount of programs per
How to set the number of programs per day on TSTAT? Read More »
• Press Clk using ▼▲ set hour. • Press Clk using ▼▲ set min. • Press Clk using ▼▲ set day. • Press Mode to exit. Note. The 12hr clock is used in the °F display setting. The 24hr clock is used in the °C display setting. See instruction manual for more detailed instructions.
Setting the Time and Day on Easy TSTAT Flap Read More »
Follow these steps to program the OCC2 thermostat • To begin programming press ok button () for 3 seconds, the start time will be displayed. • Using the ▼▲ buttons set the time at which you wish the heaters to come on in the morning. press ok button (tick) • A temperature will be displayed.
How to programme times and temperature on OCC2 Read More »
To reset the OCC2, Insert a pin into the whole next the letter R. This will reset the thermostat back to the factory settings.
How to reset the OCC2 thermostat Read More »
To set the time and day on OCC2 Follow these steps: Insert a pin into the hole next to the clock symbol. Then using the ▼▲ buttons set the time and then press the ok button (tick). Then set the day using the ▼▲ buttons then press the ok button (tick ) (the days are
How to set the Time and Day on OCC2 Read More »
Set the Energy Monitoring as below to view energy usage • Cost = The cost per Kilowatt from your electricity provider • Load = The load of the heaters installed in Kilowatts, e.g. DSW800 = 800 watts = 0.8 Kilowatts
How do I view my energy usage and set up Energy Monitoring on the XSTAT? Read More »
We’re happy to answer all your questions about Warmup’s wide range of underfloor heating systems and thermostats.
Warmup offers an extensive range of electric and water floor systems compatible with all floor types, rooms and projects.
![Thumbnail [200x250]](/wp-content/uploads/Electric-Category-Page-Image.jpg)
![Thumbnail [200x250]](/wp-content/uploads/Hydronic-Category-Page-Image-1.jpg)
![Thumbnail [200x250]](/wp-content/uploads/6iE-Projects.jpg)
