Prepare Your Project

Warmup Primer is a ready to use, bond enhancing and solvent-free single component primer for the preparation of absorbent and non-absorbent floors and walls with or without surface heating. Ideal for use before laying Warmup Peel and Stick systems, levelling compounds and tile adhesives. Suitable for use as a deep penetrating primer on absorbent surfaces. […]

The Warmup Underlay / Dual Overlay systems are designed to work specifically with Warmup Foil Heaters only.

Each pack contains: 4 base boards & 4 top boards and covers 2.88m² of flooring.

The insulation boards are used to prevent heat escaping downwards to the subfloor, improving the efficiency of the system. Insulation boards can reduce running costs by as much as 50% because they are a highly efficient thermal barrier to cold rising from the subfloor. By reflecting the heat upwards instead of losing heat to the […]

The R value is a measure of thermal resistance used in the construction industry. The higher the R value the better an insulator (e.g. 10mm Warmup® Insulation Boards have an R value of 0.28 m²K/W and the 20mm Warmup® Insulation Boards have an R value of 0.58 m²K/W). All buildings should strive for the highest […]

Warmup® Insulation Boards are made of waterproof extruded polystyrene with a glassfibre mesh embedded on each face, onto a cement polymer adhesive. The boards are fully waterproof, preventing any water to pass through them in the way expanded polystyrene boards do. They are lightweight, easy to cut with a knife and install onto any surface. […]

Insulation boards are suitable for installation on both floors and walls, making them a versatile solution for underfloor heating projects and tiled surfaces. When used as a floor tile backer board, they provide a strong, stable base capable of supporting heavy loads while improving the efficiency of underfloor heating by reducing heat loss into the […]

If your room is well insulated and complies with modern insulation levels you should be able to use Warmup as the sole heat source. However, if your house is an older property with lower insulation properties it is likely that an additional heat source may be required. Heat loss calculations can be carried out by […]

Yes. The DCM-PRO system is designed to help reduce the risk of cracks developing in tiled floors by incorporating a decoupling membrane that absorbs movement between the subfloor and the tiled surface. As buildings naturally expand and contract due to changes in temperature and moisture, the subfloor and floor finish can move at different rates. […]

This page outlines installation recommendations when installing over a plywood sub-floor.