Troubleshooting

In this video we will show you how to peel off the screen protector on the 6iE Mini.

In this how to video we show you how to peel off the screen protector on your Warmup 6iE Smart WiFi Thermostat.

The thermostat is set in ‘Air’ Mode. The maximum set temperature in air mode is 30°C. The maximum temperature for Floor Mode is 40°C Delicate floor coverings need to have their temperatures limited. If the finished floor is set for wood, laminate, vinyl, a safety feature built into the thermostat will not allow you to […]

On the initial set up a set back temperature should have been set, this is temperature that you would like the underfloor heating to drop down to during the off periods. The setback temperature is the temperature the system drops down to when you do not wish the heating to be on. If the setback […]

If the 4iE screen is blank check the following: Check that the standby /display brightness is not on the lowest setting “0”. If you have set the standby brightness to 0 you will need to press the standby button at the bottom of the main screen to activate the screen so that you can see […]

If you find that the air temperature on the 4iE is not correct, check that the thermostat has been set up correctly. The air sensor in the thermostat should not be located near any heat-inducing elements, such as spotlights or full sunlight. On initial 4iE setup, if the incorrect total wattage of the heaters or […]

If your 4iE cannot find the SSID WiFi name please check the following: Check that your WiFi network is 2.4GHz. If it is, next make sure that the SSID name has not been hidden. You will need to go into your router settings to check this. ( usually it would have a tick box next […]

Warmup’s 3iE® offers a choice of three sensor settings. These include an air, external and floor sensor setting to allow more accurate control of your underfloor heating system.  

The heating wire in some of our heaters can be adjusted to better fit the space in which it is to be installed. The Loose Wire system gives you the flexibility to alter the wire spacing. The spacings between each run of heating element can be brought down to a minimum of 50mm and a […]